ALLIGATOR CLIPS [with Leads]: Set of 10x

ALLIGATOR CLIPS [with Leads]: Set of 10x

• Comprises ten 400 mm long lengths of wire with an alligator clip attached to each end.
• They do not have the same type of  alligator clip as cat. SWB0006, cat. SWB0007 and cat. SWB0053, as these parts are not as large or robust, and do not have the tubular end to fit a banana plug.
• Each alligator clip is covered with an insulated plastic sleeve the same colour as the insulated wire leads.
• Lead colours – two each of white, red, yellow, green and blue.

(Wikipedia excerpt: .."...A crocodile clip or alligator clip[1] is a plier-like spring-tensioned metal clip with elongated, serrated jaws that is used for creating a temporary electrical connection. This simple mechanical device gets its name from the resemblance of its serrated jaws to the toothed jaws of a crocodile or alligator. It is used to clamp and grab onto a bare electrical cable to a lead on a battery or some other electrical component. The clip's tapered, serrated jaws are forced together by a spring to grip an object.

A Clothespin or Kelvin clip is a special form of crocodile clip whose jaws are insulated from each other, allowing two isolated wires to connect to a single test point. This enables 4-wire measurement of circuits with very low resistances. When manufactured for electronics testing and evaluation, one jaw of the clip is typically permanently crimped or soldered to a wire, or is bent to form the inner tubular contact of a ~4 mm (0.16 in) female banana jack, enabling quick non-permanent connection between a circuit under test and laboratory equipment or to another electrical circuit. The clip is typically covered by a plastic shroud or "boot" to prevent accidental short-circuits....")